나만의 카테고리 지정 도움말

나만의 카테고리를 설정하시면 상품검색을 매우 편리하게 이용하실 수 있습니다.
설정된 카테고리 클릭시 바로 지정된 상품 분류로 이동합니다.
마이페이지>나만의 카테고리에서 명칭변경, 순번변경, 삭제등을 하실 수 있습니다.


  • 상품명CB77086-4G X-Maxx 8S 4WD Brushless RTR Monster Truck GREEN 한정판 (배터리 & 충전기 별매)  
  • 브랜드트랙사스
  • 상품코드CB77086-4G
  • 판매가격1,298,000원
  • 포인트 12,980점 (회원에게만지급)
  • 메모

    메모하기 도움말

    메모를 해두시면 상품 구매 시 유용하게 활용하실 수 있습니다.
    마이페이지>나의작성글>메모상품보기 에서 회원님이 메모하신 전체상품을 한 눈에 확인하실 수 있습니다.

  • 매장재고 주문접수 후 수입사에 재고,수량 확인 후 배송되는
    상품으로 당일 또는 2~3일 이내 배송가능한 상품
  • 주문수량   금액

목록보기 찜하기 즉시구매 장바구니

재고확인

"
































Traxxas TQi Radio Systems
Before attempting to program your VXL-8s, it is important to make sure your TQi
transmitter is properly adjusted (set back to the factory defaults). Otherwise, you
may not get the best performance from your speed control.
The transmitter should be adjusted as follows:
1. Set the throttle neutral switch to the 50/50 setting. This adjusts the
transmitter’s throttle trigger throw to 50% for throttle and 50% for braking and
reverse. Experienced users may wish to use the 70/30 setting if more broad
proportional control is desired in forward than with braking and reverse. This
might be desirable in a racing environment where reverse is disabled.
2. Set the throttle trim control to the middle 0 setting.
3. You are now ready to program your speed control.
Aftermarket (Non-Traxxas) Transmitters
The following instructions are provided as a general reference only for those who
are using non-Traxxas transmitters. Consult your transmitter’s instructions for
information on how to change the settings.
1. Set the High ATV (adjustable travel volume) or EPA (end point adjustment) to the
maximum setting. This is the amount of servo throw at full throttle.
2. Set the Low ATV, EPA or ATL (low side only trim adjustment) to the maximum
setting. This is the amount of servo throw at full brakes or reverse.
3. Set the throttle trim to the middle (neutral setting).
4. Set the throttle channel reversing switch to either position. Do not change the
switch position after programming.
5. Set the trigger throw adjustment to 50% throttle and 50% brake (either
mechanical or electronic).
6. Set the exponential setting (if equipped) to the zero or fully linear setting.

"

Troubleshooting Guide

녹색LED 점멸시 수신기 이상 여부 확인 바랍니다.
This guide describes possible speed control problems, causes, and simple solutions.
Check these items before contacting Traxxas.
Steering channel works but the motor will not run:
• The speed control has thermally shut down. Allow the speed control to cool down.
Use a milder motor or a smaller pinion gear. Check the drive train for restrictions.
Check the motor connections. Check the motor.
• Make sure the speed control is plugged into the throttle channel of the receiver.
Check operation of the throttle channel with a servo.
• Bad batter(ies) or motor. Check the operation with known good batter(ies) and
motor.
• VXL-8s: Possible internal damage. Return the VXL-8s to Traxxas for service.
Motor runs backwards:
• Motor wired backwards - Check the wiring and correct.
Motor runs as soon as the battery is plugged in:
• Internal damage; return VXL-8s to Traxxas for service.
VXL-8s will not go into programming mode:
• Make sure the VXL-8s is plugged into Channel 2 (the throttle channel) on the
receiver. If it is plugged into the battery terminal, it will not go into programming
mode.
• Be sure the VXL-8s is turned off before trying to program or select a profile.
• Unplug battery, reconnect, and repeat programming instructions.
• Check if transmitter is turned on.
Receiver glitches/throttle stutters during acceleration:
• The receiver or antenna is too close to power wires or the batteries.
• Bad connections. Check the wiring and connectors.
• Motor worn. Replace the motor.
• Excessive current to motor (over-geared motor). Use a smaller pinion gear.
• Battery voltage low. Recharge and/or verify charged status.
• Disconnected brushless motor lead. Reconnect according to appropriate wiring
diagram.
Model runs slowly / slow acceleration:
• Check the motor and battery connectors.
• Check to see if the VXL-8s is in Profile #3 (50% throttle).
• Bad batter(ies) or motor. Check the operation with known good batter(ies) and
motor.
• Incorrect transmitter or speed control adjustment. Refer to the Transmitter Setup
and VXL-8s Setup Programming sections.
• VXL-8s is in Thermal Shutdown Protection. Allow to cool and check for proper
gearing.
• VXL-8s has entered Low-Voltage Protection.
Model will not go in reverse:
• Make sure the throttle trim is in the correct position (LED on VXL-8s should be lit
solid at neutral throttle).
• Check for correct VXL-8s profile (Profile #2 does not have reverse).

상품Q&A
구매하시려는 상품에 대해 궁금하세요?
신속하고 정확한 답변으로 궁금증을 해결해 드리겠습니다.
문의상품 CB77086-4G X-Maxx 8S 4WD Brushless RTR Monster Truck GREEN 한정판 (배터리 & 충전기 별매)  
제목

질문

답변글은 상품Q&A에 등록되며, 마이페이지>상품Q&A에서도 확인하실 수 있습니다.

레이어팝업
브랜드선택