나만의 카테고리 지정 도움말

나만의 카테고리를 설정하시면 상품검색을 매우 편리하게 이용하실 수 있습니다.
설정된 카테고리 클릭시 바로 지정된 상품 분류로 이동합니다.
마이페이지>나만의 카테고리에서 명칭변경, 순번변경, 삭제등을 하실 수 있습니다.

상품명TBR10047 TBR XV4 Front Bumper - ARRMA Big Rock (LED 미포함)
브랜드T-Bone Racing
상품코드TBR10047
판매가격45,000원
포인트 450점 (회원에게만지급)
메모

메모하기 도움말

메모를 해두시면 상품 구매 시 유용하게 활용하실 수 있습니다.
마이페이지>나의작성글>메모상품보기 에서 회원님이 메모하신 전체상품을 한 눈에 확인하실 수 있습니다.

매장재고 주문접수 후 수입사에 재고,수량 확인 후 배송되는
상품으로 당일 또는 2~3일 이내 배송가능한 상품

주문수량 금액 원

Our XV4 Front Bumper replaces the stock bumper assembly and is a 4 piece unit.

The Front Bumper Skid (FBS) mounts on the bottom with 4 screws and 2 aluminum stand offs. The XV4 bof (bolt on front) bumper mounts to the skid at 3 locations. Front Brace mounts to existing bumper location and floats at the bumper.

This listing comes with the following for ARRMA Big Rock:

One TBR XV4 bof Front Bumper - MPN R031
One TBR FBS Front Bumper Skid - MPN A112
One TBR Front Brace - MPN H111
Two TBR #H Rods - MPN Y187
Weight - 6.2oz / 176 grams

Note:1- All T-Bone products are manufactured after order has been placed.

Note:2 This bumper does NOT come with the LED Light Bar. Search for the #10052 part number for the XV4 bumper that comes with the light bar.

Instructions:

Remove stock front bumper, two skid screws on bottom and two M3 screws by servo.
Mount Front Brace to the lower boss that held stock bumper on. Place it on top of lower one. Insert supplied aluminum spacers to the top of the brace and under upper boss.
Use two M3 x 25mm cap head screws to pass through the bosses, aluminum spacers and brace and thread into lower boss. (Note: 2-M3 Lock nuts are supplied to use at your discretion on the bottom side of lower boss.
Place two 6 x10 aluminum spacers into recessed holes at each side of servo on chassis.\
Next insert two M3 x 30 flat head socket screws through the M3 holes on our FBS part # A112 and thread through the aluminum spacers and into chassis.
Finally, thread two M4 x 25 flat head socket screws through the FBS and the bof front bumper to the chassis. Tighten all screws, but do not over tighten.
A piece of rubber has been supplied to protect the LED wires as they pass between the front shocks.